The short answer
MT-2 is supplied lyophilised and is unusually stable for a peptide. Cyclisation, a D-amino acid and capped termini remove most enzymatic vulnerability, and with no cysteine or methionine the common chemical degradation routes do not apply either.
Key facts
- Supplied as
- Lyophilised powder
- Cyclic
- Yes (no free termini)
- D-amino acid
- Present, blocks proteases
- Disulfide chemistry
- None (no cysteine)
- Oxidation
- No methionine
- Tryptophan
- Present, light-sensitive
Why it is more robust than most
Four independent stability features. Cyclisation removes the free termini exopeptidases need. The D-phenylalanine blocks stereospecific cleavage. N-acetylation and C-amidation cap both ends. This is a molecule designed to survive, and the design works.
What is chemically absent
No cysteine, so no disulfide formation or scrambling, unlike glutathione, where that is the daily problem, or IGF-1 LR3, where three disulfides must fold correctly. No methionine, so no oxidation satellite at +16 Da. Two of the three most common peptide degradation routes simply do not apply.
Research material referenced
MT-2 10mg, third-party HPLC tested
The one residue that does need care
Tryptophan at position 6. Tryptophan is the most photochemically reactive of the twenty standard residues and degrades under UV exposure. Protecting from light is therefore a real requirement here rather than a generic precaution. The same consideration applies to DSIP and Semax, which also contain it.
The analytical benefit of that same residue
Tryptophan absorbs strongly near 280 nm, so quantification by absorbance is straightforward. This is a real advantage over KPV, GHK and other short peptides in this catalogue that contain no aromatic residue at all and cannot be measured that way.
Practical handling
Lyophilised, cold, dry and dark, with light protection meaning what it says. Reconstitute gently down the vial wall and swirl rather than shake. Aliquot to avoid freeze-thaw cycling. The chemical robustness is real but it does not extend to the physical stresses of repeated handling.
Frequently asked questions
How do you reconstitute Melanotan 2?
Add bacteriostatic water slowly down the inside wall of the vial rather than directly onto the powder, and let it dissolve without shaking. Swirl gently if needed. The volume chosen sets the concentration and nothing about the vial dictates a particular one.
How much bacteriostatic water for a 10mg vial?
It is arithmetic, not a rule: 2 ml into a 10 mg vial gives 5 mg/ml, 5 ml gives 2 mg/ml. Laboratories pick whatever makes the intended working concentration convenient to measure, and record it.
How should Melanotan 2 be stored?
Keep the lyophilised vial at -20°C, sealed and protected from light, as this compound is light-sensitive. Once reconstituted, store at 2-8°C and use within 28 days. Do not refreeze after reconstitution.
Is MT-2 chemically stable?
Unusually so. Cyclisation, a D-amino acid and two capped termini remove most enzymatic vulnerability, and there is no cysteine or methionine.
What needs the most care?
Light protection. Tryptophan at position 6 is the most photochemically reactive standard residue.
Can it be quantified at 280 nm?
Yes. The tryptophan absorbs strongly there, unlike the short aromatic-free peptides elsewhere in this catalogue.
Continue researching
Related guides and reference material.
Primary sources & clinical trials
Published papers, trial registrations, regulator pages and company announcements. Links open the original.
Written and published by UK Peptides, the trading name of AURYXRESEARCH LTD (company 17388727, registered in England and Wales).
Questions or a correction? Email hello@ukpeptides.org or call +44 7426 987848.
More MT-2 (Melanotan II) articles
- Does Melanotan 2 Work Without UV?The receptor mechanism does not require UV, and the approved analogue proves pigmentation can rise without it. What that does and does not establish for MT-2.
- Melanotan 2 Onset: What Can and Cannot Be SaidNo controlled trial has measured a time course for MT-2. What melanin biology sets as a floor, and what the licensed analogue's data actually shows.
- Why This Site Publishes No Melanotan 2 DoseNot evasion - there is no established human dose to publish. The compound is unauthorised, the MHRA has warned about it, and the reported harms are specific.
- What Before-and-After Photographs Can and Cannot ShowLighting, camera and sun exposure vary more between photographs than skin does. What would count as evidence, and what the licensed analogue measured.
- What Is Melanotan 2? Structure, Origin and StatusA cyclic heptapeptide at 1024.2 Da derived from alpha-MSH. What it is, how it differs from the approved Melanotan I, and what the safety literature reports.